Yokomo B9-412FWA Front Stabiliser Set for BD9 Chassis  [B9-412FWA]

Yokomo B9-412FWA Front Stabilizer Wire Set (Laser meeling 3pcs)
Price:
NZD$15.32
Brand:
Yokomo
Model:
B9-412FWA
GTIN:
0639342204519
Condition:
Brand New
Write a review

Refine Your BD9 Setup with Yokomo B9-412FWA

The Yokomo B9-412FWA Front Stabiliser Wire Set lets you tailor the BD9 chassis handling with three distinct wire choices. Swap wires to suit carpet, asphalt or low-grip layouts and achieve a more consistent car behaviour.

Adjust Roll to Match Surface Grip

For club and regional racers the ability to change stabiliser wires offers a simple way to control roll and balance. The set lets you fine-tune front-end motion so your BD9 feels more predictable across varied conditions.

Works with Multiple BD Variants

The Yokomo B9-412FWA fits a range of BD series cars such as MRTC-BD919, MRTC-BD919S and MRTC-BD10FF, which makes it handy for drivers who run several BD-based chassis.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How do I decide which wire suits carpet tracks?

On carpet you often want a bit more roll to help the tyres scrub in; try the softer wire first then step up if you see too much understeer.

Are any extra parts needed to install the set?

The set uses the existing stabiliser mounts on BD9 variants, so no special adapters are usually required. Keep common hand tools at the pit box for swaps.

How often should I check the wires for wear?

Inspect wires after heavy running or impacts. Look for bends or fatigue and replace the wire if it shows distortion to keep tuning consistent.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved