Yokomo BD12 Graphite Rear Shock Tower Factory Pro O-YCP019 Special Edition  [FP-O-YCP019]

Price:
NZD$20.95
Brand:
Factory Pro
Model:
FP-O-YCP019
Condition:
Brand New
Write a review

Swap in a Factory Pro O-YCP019 for Better BD12 Stability

The Factory Pro O-YCP019 graphite rear shock tower is crafted for the Yokomo BD12 to boost structural integrity where the shocks mount. It is aimed at drivers who want stable, repeatable suspension behaviour during race runs.

Lightweight Material, Stable Result

Made from premium graphite, this tower trims unsprung mass while resisting flex under load. The result is improved cornering precision and easier setup dialing for different track conditions.

Straightforward Fitment

Designed to match the BD12 holes and geometry, the Factory Pro rear tower fits without aftermarket adjustment. The subdued matt surface gives a neat low profile look without adding unnecessary bulk.

Can I run this on carpet tracks?

Yes. The added stiffness from the O-YCP019 can help on high grip carpets by reducing unwanted chassis flex and improving consistency.

Is this compatible with standard BD12 shock setups?

It supports stock shock positions and spring rates. You may need to tweak shock length or mounting positions to fine tune roll characteristics.

Will it change ride height?

The tower itself does not change ride height but its stiffness can alter compression behaviour, so small trim adjustments might be useful after fitting.

Any tips for installation?

Use thread locker where appropriate and tighten screws evenly to avoid preload on the graphite. Inspect mounting holes for proper engagement after first runs.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved