Yokomo B-MAX4 Steering Bell Crank Upgrade 7075 - AM-MAX4-006 by Arrowmax  [AM-MAX4-006]

Arrowmax AM-MAX4-006 Bell Crank Set (L&R) (7075)
Price:
NZD$67.10
Brand:
Arrowmax
Model:
AM-MAX4-006
Condition:
Brand New
Write a review

High precision bell crank for B-MAX4

The Arrowmax AM-MAX4-006 bell crank set is crafted for use on Yokomo B-MAX4 chassis as a steering hop-up. Machined from 7075 aluminium, the left and right cranks transmit servo input into steering linkage movement with improved rigidity.

Check fitment against your B-MAX4 steering assembly, reuse original pushrods where appropriate, and inspect bearing clearance and pushrod lengths when setting up. This hop-up suits club racers and hobbyists tuning steering feel on 1/10 on-road machines.

Specifications

  • Item: Bell crank set (L&R)
  • Material: 7075 aluminium
  • Model Number: AM-MAX4-006
  • Compatibility: Yokomo B-MAX4

Fit the AM-MAX4-006 where consistent steering response is a priority, and always confirm steering centring and smooth travel before each session.

Is drilling or rework needed for a B-MAX4 fit?

Typically no machining is required for a standard B-MAX4 chassis. Always trial-fit and check that bearings sit flush and pivot holes line up.

Will this change steering geometry significantly?

Geometry changes are usually minor, but altering crank thickness or offsets can affect toe and Ackermann. Recheck alignment and steering centring after install.

Can I expect longer service life with this part?

7075 aluminium offers greater wear resistance than softer alloys, so you should see improved longevity under normal track use.

Any post-fit maintenance suggestions?

After fitting, run the steering through its range, tighten link fasteners to spec, and inspect for any rubbing points or binding during steering travel.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved