This RC-scale center link pin secures the DPM steering wiper assembly on hobby chassis. It is intended to hold the wiper firmly in position to reduce unwanted movement in the steering linkage while driving.
The package contains two pieces as supplied, providing the amount needed for the supported chassis shown below. Installing the part is a direct replacement or securing of the existing steering wiper link, then checking alignment and ensuring free movement throughout the steering travel. No further hardware specifics are supplied in the source notes.
From a setup perspective, this pin is a basic retention part that helps stabilise steering geometry by locking the wiper relative to the centre link. Fit it when you need repeatable steering response after making setup changes to toe, caster, or steering throw.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved