Yokomo D-156P DPR Compatible Hinge Pins for Upper A Arm  [D-156P]

Replacement pins for DPR upper A arm

This hinge pin set is intended as a direct replacement for the pins used in the DPR front upper A arm. The kit provides 2 pcs to address worn or damaged pivot hardware.

Fitment is limited to the DPR variants listed below; the part restores a secure pivot and helps retain intended suspension geometry at the front upper A arm. Replacing degraded pins preserves alignment and consistent suspension response during setup and running.

Installation overview: detach the upper A arm from the chassis, remove the existing pins, reinstall any bushings or spacers as originally positioned, and insert the new pins until they are properly seated. Once installed, move the suspension through its range to confirm correct movement and retention.