Yokomo FA-19218 jp FANTOM PCB Hall sensor board compatible with HELIX/ICON  [FA-19218]

FANTOM sensor module overview

The Yokomo FA-19218 jp replacement PCB provides the Hall sensor interface for FANTOM-series brushless motors. It is built to serve HELIX and ICON family motors and accepts rotor diameters of 24mm or 25mm. This board is intended for RC motor service and repair to return accurate position sensing for sensor-capable setups.

Compatibility covers HELIX, HELIX V2, ICON V2, ICON V3 and ICON-Torque versions of FANTOM motors, and the board is specified for use with 24mm and 25mm rotors. Confirm both rotor size and motor family before installation to ensure correct spacing and signal timing.

The component is a maintenance item rather than a direct performance modifier; it supplies the sensor signals required by the ESC for commutation and low-speed control. Installers should inspect internal connector seating and verify sensor orientation against the original board.

Use this board to restore sensor function in FANTOM motors installed on the listed Yokomo chassis. Ensure rotor diameter and motor variant match before fitting and follow standard motor disassembly and reassembly procedures.