Yokomo MD-DHA-3 Aluminum Diff Height Adapter Kit for Master Drift MD3.0  [MD-DHA-3]

Aluminium Differential Height Blocks, Left and Right

The MD-DHA-3 is supplied as left and right machined aluminium blocks designed for the Master Drift MD3.0 series. These parts are intended for 1/10 drift chassis where small differential height changes help tune handling and traction behavior.

Compatible with the MDR-030 range, the adapter set replaces or supplements existing diff mounts to change the relative height of the differential case. The aluminium construction provides a stable mount and resists compression better than softer mounting materials.

For fitting, remove the diff assembly, position the left and right adapters on the diff housing or chassis mounting points, then secure with the original fasteners. After a brief run, recheck alignment and fastener torque to ensure reliable operation.

Tuning tip: altering differential height will change driveline angles and can modify steering response and rear grip; adjust in small increments and document each change to isolate effects.

When logging setup trials, note diff height and related chassis feedback; the MD-DHA-3 enables repeatable experiments without changing internal diff components.