Yokomo MS-002S-2 Steel Chassis Plate for Master Speed MS2.0  [MS-002S-2]

Yokomo MS-002S-2 jp
Price:
NZD$251.80
Brand:
Yokomo
Model:
MS-002S-2
GTIN:
639342231041
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - MSR-010 category
Write a review

MS2.0 steel chassis overview

This steel main chassis is supplied as a direct accessory for the Master Speed MS2.0 range and is intended solely as a scale RC main chassis component. Because the plate is steel, overall mass increases compared with alloy or composite options and the mounting points are lowered to move the vehicle's centre of gravity downward.

Lowered fixing positions affect suspension droop and body clearance; during installation check that screw alignment is correct and make stepwise adjustments to ride height. Anticipate retuning spring preload and anti-roll settings to complement the changed mass distribution rather than modifying drive or electronic hardware.

Specifications

  • Item Main chassis
  • Material Steel
  • Model Number MS-002S-2
  • Compatibility MSR-020S / MSR-020 / MSR-020A

Compatible Models

  • MSR-020S
  • MSR-020
  • MSR-020A

Choose this chassis when a denser, lower-mounted plate is needed to influence lateral balance and roll response; always confirm clearances and adjust suspension after fitting.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is this chassis a direct bolt-on for MSR-020S pattern cars?

Yes, it targets the MSR-020 family, but you must verify that your car uses the MSR-020S/MSR-020/MSR-020A mounting pattern before installing to avoid misalignment.

What should I watch for during installation?

Check that screws pass cleanly through the lowered holes, inspect spacers for correct thickness, and fit incrementally while verifying ride height and droop to prevent binding or interference.

Will this require different springs or anti-roll bars?

The chassis changes mass distribution, so softer or firmer spring choices and anti-roll adjustments may be needed to restore desired handling; tune progressively rather than making large initial changes.

Should I be concerned about body clearance?

Yes, lowered plate height can reduce body and suspension clearance; after fitting, verify body mounts and suspension travel to avoid contact at full droop or compression.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved