Yokomo MS1.0 Front Lower Arm Factory Pro O-YCP032R - Performance Part [FP-O-YCP032R]

Price:

NZD$19.02

Brand:

Factory Pro

Model:

FP-O-YCP032R

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Front Lower Arm Overview for MS1.0

The Factory Pro O-YCP032R front lower arm fits the Yokomo MS1.0 chassis and is produced as a single, durable component. Its flat-matt finish resists glare and helps maintain a tidy appearance while providing solid mechanical reliability. Runners looking for steady steering feel and reduced twitch at speed will find this a useful upgrade.

Is special hardware needed to install this part?

Installation usually uses the stock screws for the MS1.0, but check screw length and thread engagement. Replace any rounded fasteners for a secure fit.

Will the flat-matt finish affect weight much?

The finish is cosmetic and does not significantly change mass. The single-piece construction is chosen for stiffness and longevity rather than weight savings.

Any setup tips after fitting the arm?

After fitting, recheck camber and toe settings and run a few shakedown laps to confirm the steering feel. Small trim adjustments to toe can compensate for the stiffer arm.