Yokomo PG-4835A Lightweight 35T 48DP Aluminium Pinion  [PG-4835A]

Price:
NZD$13.44
Brand:
Yokomo
Model:
PG-4835A
GTIN:
0639342207947
Condition:
Brand New
Write a review

Precision aluminium pinion built for consistent gear mesh

The Yokomo PG-4835A offers a durable aluminium construction and a hard-coated face to keep tooth profiles true under regular use. With 35 teeth and a 48 pitch standard, it pairs easily with common spur gears used in many RC setups.

Reduce rotational mass for better throttle response

This pinion is machined to be light yet strong, helping lower rotating inertia so your model picks up speed quicker. The durable coating helps limit wear so you can rely on steady performance across sessions.

Easy upgrade for 1/10 scale builds

Well suited to 1/10 scale race and trail models, the PG-4835A installs without fuss in compatible drivetrains. It is a practical swap when adjusting gear ratios or replacing an older pinion during routine servicing.

Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.
Check the pinion bore and set screw arrangement against your motor shaft diameter; many motors use common sizes but confirmation avoids fit issues.
Light grease on the spur gear and correct mesh are usually sufficient; avoid heavy oils on the pinion surface as they can attract grit that increases wear.
Changing pinion tooth count alters final drive ratio, which affects acceleration and top speed. A 35T choice balances acceleration with a moderate top speed for many 1/10 setups.
Lifespan depends on conditions and maintenance; regular mesh checks and keeping gears clean will help the hard coating deliver extended service life.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved