Yokomo PG-6445A 45T Hard Coated Aluminium Pinion DP64  [PG-6445A]

Price:
NZD$13.42
Brand:
Yokomo
Model:
PG-6445A
GTIN:
0639342208234
Condition:
Brand New
Write a review

Tune your RC drivetrain with Yokomo PG-6445A

The Yokomo PG-6445A is a hard-coated aluminium pinion gear engineered for model builders wanting accurate, low-mass gearing. With its 64-pitch design and 45 tooth count, it helps trim rotating weight without sacrificing engagement quality.

Advantages of aluminium pinions

Lightweight aluminium pinions like the PG-6445A reduce inertia for snappier throttle response. The protective hard finish helps the gear withstand repeated meshing and everyday running conditions.

Where this pinion is typically used

This pinion works with spur gears that share the 64-pitch specification and is a good match for a wide range of 1/10 scale on-road and off-road rigs that prioritise precision gearing.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can I run the PG-6445A on a quick track setup?

Yes. When matched with the correct 64-pitch spur and set to proper mesh, its low mass supports higher acceleration and quick response.

Does the tooth count matter for fitment?

Tooth count affects overall gearing ratio. The 45T PG-6445A will change final drive ratio compared to other pinions, so pick the tooth number that suits your desired speed and torque.

Any installation tips I should follow?

Check and set the gear mesh precisely, keep the area clean during fitment, and verify smooth rotation before full power runs.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved