Yokomo S4-008F2GA Graphite Front Suspension Arm for YZ-4SF2 Special Edition  [S4-008F2GA]

Yokomo S4-008F2GA Graphite Front suspension arm(TypeB/2hole/?3.5pin) for YZ-4SF2
Price:
NZD$22.71
Brand:
Yokomo
Model:
S4-008F2GA
GTIN:
0639342209767
Condition:
Brand New
Write a review

Graphite Front Suspension Upgrade for YZ-4SF2

The Yokomo S4-008F2GA is a direct-replacement graphite front suspension arm developed for the YZ-4SF2 chassis. Its graphite-containing resin construction raises component stiffness, producing clearer steering input and improved traction on a range of surfaces. The part retains inner pin holes of Φ3.5mm and outer pin holes of Φ2.5mm to preserve precise suspension geometry.

Material Advantages for Club and Race Use

Graphite-enhanced resin offers higher rigidity than standard compounds, translating to sharper handling and better feedback at the wheel. Drivers will notice reduced flex under load, which helps maintain line consistency through corners.

Compatibility Details and Quick Fit

This arm is compatible with chassis types such as B-YZ4SF2-1, MOR-010, and MOR-020 and installs using the stock mounting points. No trimming or extra hardware is typically necessary for a clean swap.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this arm make my YZ-4SF2 more responsive?

Yes, increased stiffness from the graphite-resin mix generally results in quicker steering response and crisper feedback from the front end.

Are any chassis mods needed to fit the S4-008F2GA?

No modifications are usually required; the arm uses the stock pin and mount pattern for direct installation on supported chassis.

How should I maintain graphite suspension arms?

Clean debris after runs, inspect pin holes for wear, and avoid over-tightening fasteners to keep the arm performing consistently.

Can I switch back to stock arms easily?

Yes, swapping back to the original arms is straightforward since the S4-008F2GA uses the same mounting points and pin sizes.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved