Yokomo SD-018GB Rear Shock Tower — Graphite Upgrade for Drift Chassis  [SD-018GB]

Rear shock tower built for drift chassis

This RC-scale graphite rear shock tower is intended for use with Yokomo drift platforms and similar chassis to enhance suspension consistency under dynamic drift loads. The design concentrates stiffness at the shock mount to deliver clearer damping feedback without changing the overall chassis layout.

Installation notes: check the rear tower mounting pattern on your chassis prior to purchase, use the car's original screws and mounting points or suitable replacements, and ensure correct alignment and thread engagement during reassembly. There is no listing here of included hardware or exact hole spacings; always verify fitment against your vehicle.

Tuning role: swapping a flexible plastic tower for graphite alters the stiffness at the shock mount and can sharpen rear reaction. Treat this part as one variable in a measured tuning approach alongside shock oil, spring rates, and anti-roll settings to reach your desired drift behaviour.