Yokomo SD-303AR Rear Gearbox Input Shaft, Aluminum for DRIFT PACKAGE  [SD-303AR]

Hard-coated aluminum shaft for DP-series drift kit

This aluminum rear input shaft joins the rear gearbox to the centre shaft on Yokomo DRIFT PACKAGE chassis. Built for RC drift rigs, it trims rotating mass in the drivetrain to help produce crisper throttle reaction without altering gearbox alignment.

The part is crafted from light aluminum and finished with a hard-coat treatment to withstand wear at contact points. The set includes the shaft plus the small screws and pins required for fitting, making it suitable as a direct replacement or spare for listed DP-series rear gearboxes.

Fitting advice: align the gearbox and centre shaft before tightening, make sure set screws and cross pins are properly positioned, and place the O-ring exactly where the gearbox manual specifies to keep correct clearances. Routine tools such as hex drivers and pliers are sufficient.