Yokomo SO-415RA Aluminum Rear Hub Carrier L/R for SO series  [SO-415RA]

Yokomo SO-415RA Aluminum Rear Hub Carrier L/R for SO series
Price:
NZD$73.87
Brand:
Yokomo
Model:
SO-415RA
GTIN:
639342228669
Condition:
Brand New
Write a review
alt="Yokomo SO-415RA Aluminum Rear Hub Carrier L/R for SO series" title="Yokomo SO-415RA Aluminum Rear Hub Carrier L/R for SO series"

Durable aluminum hub carrier for SO series

Specifically produced for SO series 2WD off-road cars, this aluminum rear hub carrier supersedes the standard resin piece to increase component rigidity and reduce deformation during heavy use.

In practical running the aluminum carrier offers greater resistance to bending during hard landings and forceful acceleration, which helps preserve setup and maintain handling consistency lap after lap. The same height insert compatibility is maintained, so you can keep your roll-center and skid-angle choices.

Because the bores are finished accurately, fitting fresh bearings is recommended; reused bearings pressed into tight fits may be difficult to extract later. The part focuses on reliability and tunability rather than visual changes.

Specifications

  • Item: Aluminum Rear Hub Carrier L/R
  • Material: Aluminum
  • Model Number: SO-415RA
  • Compatibility: SO series 2WD off-road, Universal, ROR-020, ROR-020RTR

Compatibility

  • SO series (2WD off-road)
  • Universal
  • ROR-020
  • ROR-020RTR

This aluminum upgrade is for racers who prioritise a firmer rear end and consistent handling; install new bearings and verify roll-center settings after fitting to get the best durability and performance.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How much stronger is the aluminum carrier compared with the resin original?

Aluminum increases structural stiffness at the hub versus resin; while exact numbers depend on design, users will notice reduced flex during impacts and under heavy acceleration, which helps maintain handling geometry.

Is the finish resistant to corrosion or wear?

The machined aluminum finish is robust for normal RC racing conditions; routine inspection for nicks or wear after rough runs is advised, and light corrosion protection is recommended if exposed to wet environments.

Will repeated crashes deform the aluminum like resin might crack?

Aluminum typically bends or dents under extreme loads rather than shattering like resin, which can make damage easier to detect and sometimes repair; however severe impacts can still deform the part.

Does the precision machining affect long term fit?

Yes. The tighter tolerances produced by final machining preserve alignment and reduce unwanted movement, but they also mean bearings should be replaced during installation to ensure reliable long term fitment.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved