Yokomo Y2-003MGA Upper Deck for YD-2/PLUS/EX  [Y2-003MGA]

Yokomo Y2-003MGA Matte Graphite Upper Deck for YD-2/PLUS/EX
Price:
NZD$40.45
Brand:
Yokomo
Model:
Y2-003MGA
GTIN:
0639342211777
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - YD-2 category
Write a review

Upper Chassis Brace Overview for YD-2

The Yokomo Y2-003MGA matte graphite upper deck is intended as a direct replacement and a selectable setup component for the YD-2 series. It is the standard upper deck supplied with the YD-2 PLUS and is commonly fitted across multiple YD-2 variants.

This upper deck functions as a chassis brace that influences stiffness and the mounting geometry of upper components. Keep factory mounting points and original fasteners where possible, and only change hardware lengths if a different setup explicitly requires it.

Specifications

  • Item Upper deck
  • Material Matte graphite
  • Model Number Y2-003MGA
  • Compatibility DP-YD2EX / DP-YD2EPLS / DP-YD2EX2 / DP-YD2RPLS / MRTC-YD2 / MRTC-YD2CK / DP-YD2E / DP-YD2EG / DP-YD2ES / DP-YD2AC / DP-YD2ACA

Opt for the Y2-003MGA when you need the standard YD-2 PLUS upper deck geometry in a matte graphite finish for consistent setup comparisons and replacement needs.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What tools are needed to fit the Y2-003MGA?

Basic hand tools such as a small Phillips or hex driver for your stock screws are sufficient. Verify screw lengths and standoff condition before final assembly to avoid thread damage.

Does this replace the factory deck on YD-2 PLUS?

Yes, the Y2-003MGA is the standard deck used with YD-2 PLUS and fits as a direct swap on compatible YD-2 variants without the need for modifications.

Are different fasteners ever required?

Most installations reuse the original fasteners. Only change to different lengths if your selected setup uses alternative standoffs or spacers that alter clearance.

How do I check fit after installation?

After fitting, confirm there is no binding of steering linkages and that the deck clears servos and electronics. Recheck screw torque after a short test run.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved