Yokomo Y2-017SA Shock Tower Set for YD-2S (Front & Rear)  [Y2-017SA]

Yokomo Y2-017SA Front/Rear Shock Tower (Plastic) for YD-2S
Price:
NZD$19.88
Brand:
Yokomo
Model:
Y2-017SA
GTIN:
0639342212323
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - YD-2 category
Write a review

Plastic mounting towers for YD-2S drift chassis

The Yokomo Y2-017SA front and rear shock tower kit is a plastic replacement intended for YD-2S drift chassis. It functions to secure the upper shock mounts and link suspension forces into the main chassis rails.

Installation notes: these tower pieces attach to the stock YD-2S mounting points and are designed to replace the original components without altering the shocks themselves. During fitment, verify shock shaft alignment and secure fasteners to match the original setup. Make sure there is adequate clearance for full travel to prevent the shafts from rubbing the tower edges.

Tuning role: by changing the position of the upper shock mounting points you can influence camber change and roll centre behaviour, allowing measurable adjustments to roll and pitch response for drift setup tweaks or handling evaluation.

Compatibility: Supported Chassis DP-YD2S / DP-YD2SG / DP-YD2S-PL / DP-YD2SS / DP-YD2SX / DP-YD2SX2 / DP-YD2SX2R / DP-YD2SX2P / DP-YD2SX3 / DP-YD2SX3R / DP-YD2SX3P / DP-YD2RX / DP-YD2RXR / DP-YD2RXP / DP-YD2RXTB / DP-YD2RXTP / DP-YD2RXTR.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How robust is the plastic used in Y2-017SA?

The Y2-017SA set is manufactured in plastic suited for standard replacement use; it offers appropriate stiffness for mounting upper shock points while remaining lightweight. For heavy impacts, inspect the parts regularly for signs of wear.

Will the towers tolerate repeated tuning changes?

Yes. As long as fasteners are correctly torqued and you avoid over-tightening, the towers are intended to accept multiple repositions of the upper mounts for tuning without degrading fitment.

Do I need any special tools to fit these?

No special tools are required beyond the standard small hex drivers used for YD-2S maintenance. Ensure you use the correct driver size to avoid rounding screw heads.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved