Yokomo Y2-P08FUIA Aluminium Front Upper I-Arm for YD-2 - Purple  [Y2-P08FUIA]

Yokomo Y2-P08FUIA Aluminum Front Upper I Arm (Purple) for YD-2
Price:
NZD$77.61
Brand:
Yokomo
Model:
Y2-P08FUIA
GTIN:
0639342213771
Condition:
Brand New
Write a review
alt="Yokomo Y2-P08FUIA Aluminum Front Upper I Arm (Purple) for YD-2" title="Yokomo Y2-P08FUIA Aluminum Front Upper I Arm (Purple) for YD-2"
alt="Yokomo Y2-P08FUIA Aluminum Front Upper I Arm (Purple) for YD-2" title="Yokomo Y2-P08FUIA Aluminum Front Upper I Arm (Purple) for YD-2"

Upgrade Your YD-2 with Yokomo Y2-P08FUIA

Swap out brittle resin arms for the Yokomo Y2-P08FUIA Aluminium Front Upper I-Arm to boost reliability. The part is machined to give a solid front end without adding unnecessary heft to your car.

Adjustable Caster for Handling Balance

This I-arm lets you shift the spacer to change caster over a 7mm span, so you can tune understeer and turn-in balance across different track surfaces.

Built Light with Added Rigidity

The aluminium construction reduces flex while keeping mass low, helping maintain sharp steering inputs and predictable corner behaviour.

Compatibility Notes

When replacing the stock resin arm, fit the D-155 series upper I arm rod end adapter to ensure proper geometry. The design integrates with YD-2 mounting points for a straightforward installation.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can I use this on converted drift setups?

Yes, the arm suits drift and touring YD-2 variants, but confirm clearance with steering link geometry and wheel offset before running aggressive angles.

Is there a need for different rod ends?

If your setup used the original resin rod ends, install the D-155 adapter to accept the correct rod end size and preserve steering geometry.

How should I maintain the aluminium arm?

Keep pivot points clean and lightly lubricated, check fasteners after a few runs, and inspect for wear where metal meets plastic to avoid binding.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved