Yokomo YOKB2-415R Rear Upright Hub for B-Max-2  [YOKB2-415R]

Rear upright hub for B-Max-2

The Yokomo YOKB2-415R serves as a replacement rear hub carrier tailored for the B-Max-2 1/10 touring chassis. It provides the interface between the wheel hub and the rear suspension upright to maintain intended suspension geometry.

Fit and installation: designed to replace the original rear hub carrier on a B-Max-2 without altering adjacent components. When fitting, ensure the carrier seats flat against the upright, verify alignment of mounting holes, and use correct-size hex drivers. Avoid excessive torque and inspect threads and fasteners for damage prior to final assembly.

Tuning notes: installing a fresh hub carrier can recover handling precision and, where alternative carriers exist, change rear offset or mounting positions to tune camber and toe. Expect subtle changes in rear feel and adjust other setup parameters incrementally during track testing.

Service tips: inspect the carrier and surrounding hardware for wear at each maintenance interval, check bearings and wheel hex play, and replace any fatigued parts. Clean contact surfaces and remove grit before reinstalling to preserve repeatable alignment.