Yokomo YOKB4-302R Rear Gear Case for B-MAX4 III with Stabilizer Holder  [YOKB4-302R]

Yokomo B4-302R - B-MAX4 III Rear Gear Box ( With Stabilizer Holder)
Price:
NZD$24.13
Brand:
Yokomo
Model:
YOKB4-302R
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

B-MAX4 III rear gear case details

This component is an RC rear gear case intended for use on the Yokomo B-MAX4 III chassis and is supplied with a stabilizer holder as described in the name. It is intended for replacement or maintenance of the rear drivetrain while preserving the original rear layout of the B-MAX4 III.

Installation and fitment: the case fits into the rear section of the chassis where the OEM gear box sits and pairs with the standard drivetrain parts of a stock B-MAX4 III. Follow normal disassembly and reassembly procedures for rear-end service, paying attention to gear mesh and axial alignment when reinstalling.

Tuning role: the included stabilizer holder gives a place to mount a rear stabilizer bar, enabling adjustments to rear roll stiffness and balance without modifying the differential or spur/pinion setup. Replace this part when you need to restore stabilizer geometry or service a worn gearbox.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is this listed for the B-MAX4 III chassis?

It is. The part is described for the B-MAX4 III and is intended as a direct rear drivetrain replacement for that model.

Will the stabilizer holder accept standard stabilizer bars?

The stabilizer holder is integrated into the rear case to work with the chassis stabilizer system; check your bar dimensions against the mounting points for fit.

Any installation tips to ensure alignment?

During reassembly confirm the gearbox sits flush in the chassis, set gear mesh to the recommended clearance, and verify the output shafts rotate freely before securing fasteners.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved