Yokomo YOKB7-110 Touring Car Wing Plate Set, Machined Aluminum  [YOKB7-110]

Durable Machined Wing Plates for Consistent Aerodynamics

This RC-scale aluminum wing plate set is produced for touring car bodies to aid rear wing adjustments and aerodynamic setup. The plates provide a firm mounting surface where longevity and stable wing positioning are important.

Material and finish affect setup repeatability. Machined aluminum resists deformation better than plastic, helping preserve wing angle and placement across multiple runs to support steady aerodynamic balance.

Installation follows standard touring car procedures: fit the plate to the wing post area, check alignment with the body and mounting posts, then confirm wing angle before final torque. Take care not to over-stress body posts or wing tabs when tightening fasteners.

When tuning, treat these plates as a way to lock the wing geometry you prefer. Even small changes to wing angle or height influence rear downforce and transient handling, so make measured adjustments and validate them with test laps.