Yokomo YOKD123 Machined 10 Degree Lower Caster Blocks for 1/10 Touring  [YOKD123]

Yokomo D-123 - Aluminum Lower Caster Block Set 10 degree
Price:
NZD$34.52
Brand:
Yokomo
Model:
YOKD123
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - DMAX category
Write a review

10-Degree Machined Lower Caster Blocks for Setup

The Yokomo YOKD123 aluminium lower caster block set provides a dedicated 10° lower caster option aimed at precise suspension tuning. Manufactured from machined aluminium, these parts replace the original plastic blocks to deliver a firmer connection between the lower arm and the steering knuckle. This item is presented as an aftermarket tuning part to influence caster and steering behaviour rather than a standard repair component.

Installing a denser material block changes roll centre and steering return traits. Incorporate these blocks into a measured setup change when seeking sharper steering feedback or a modest increase in front-end self-centre. They are intended for 1/10 touring and comparable chassis that share compatible hub geometry.

Fitting will require basic disassembly of the suspension to access the lower pivot and knuckle; confirm hole alignment and screw lengths for your chassis before final assembly. After installation, inspect steering travel and binding, and recheck toe and camber because small caster adjustments can affect total wheel alignment.

Specifications

  • Item: Aluminum lower caster block set 10 degree
  • Material: Aluminum
  • Model Number: YOKD123
  • Compatibility: Designed for use with 1/10 touring chassis and similar RC-scale setups where lower caster blocks match hub geometry

Opt for this set when you need a metal solution for accurate caster adjustment and a robust mounting interface; verify fitment with your chassis before buying.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will these blocks fit most touring car hub patterns?

Compatibility depends on hub geometry and hole spacing. Measure your hub and knuckle locations against the block holes to confirm they align before purchasing.

Do these aluminium blocks change other geometry aspects besides caster?

Yes. Using a stiffer, heavier block can subtly shift roll centre and affect steering return; expect changes that may require small toe and camber corrections for optimal handling.

What maintenance should I expect after switching to metal blocks?

Inspect adjacent plastic parts more frequently for signs of increased wear and ensure screws remain correctly torqued. Regular checks after initial runs will help identify any stress points early.

Are special fasteners recommended for these blocks?

Fastener selection depends on your chassis. In some cases the original screws are suitable; in others you may need alternate lengths to maintain correct engagement without causing binding.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved