Designed as a direct replacement for the DIB 275mm long wheel base, this 161-tooth belt follows the FCD x 2.0 design standard to ensure correct pulley engagement and consistent performance.
Fitment is limited to the stated DIB 275mm long wheel base configuration; confirm pulley spacing and tooth alignment before final installation. Removal of the worn belt and careful routing of the new belt will help maintain equal tension across all 161 teeth.
As a consumable item used in tuning and maintenance, the belt influences drivetrain smoothness and power transfer. Replace it when teeth show wear or fraying, and verify mesh and tension after initial running to prevent premature wear.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved