The RP-6313Y6 wheel is a 1/10 scale drift item from Yokomo designed to shift contact geometry while offering a high-traction surface for predictable slides. Supplied in a single yellow finish, the 6 mm offset helps modify tyre scrub and lateral position for setup experiments.
Fitment: built for 1/10 drift applications and suitable for widely used drift hubs and rims; always double check hub hex and wheel bore measurements before fitting. Listing does not imply guaranteed fit to any one chassis without verifying hub sizing.
Installation notes: remove the existing wheel, seat this wheel ensuring correct bore and hex alignment, and secure with your original wheel nut or compatible mounting hardware. Visually check balance and confirm there is no unwanted play prior to running. Consider threadlocker on hub fasteners where vibration is a concern, and inspect after the initial outing.
Tuning role: a 6 mm offset pushes the tyre contact patch outward relative to the mounting face, changing track width and scrub behavior. Match offset selection with suspension and toe settings to tailor slide initiation and mid-drift stability.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved