Yokomo YOKSD300R25 Rear Aluminum Suspension Mount 2.5 degree  [YOKSD300R25]

Rear suspension mount, fixed 2.5 degree aluminum

The Yokomo YOKSD300R25 rear suspension mount supplies a permanent 2.5 degree rear mounting position for RC rear suspension setups, giving a metal mounting surface where a stiffer, repeatable attachment point is desired.

Manufactured from machined aluminum, the component increases structural rigidity compared with typical plastic parts and is meant for use in chassis locations designed to accept an angled rear mount. The 2.5 degree angle is integral to the part and provides a consistent geometry reference for tuning the rear end.

Fitting the mount requires confirming its orientation and fastening it with the chassis' existing rear mount hardware or the screws intended for that location. After securing the part, inspect travel and nearby components to ensure the new mount does not contact other parts during operation.

Use case: employ this mount when you need a repeatable metal mounting surface for comparing setup changes or when a firmer rear mounting point is preferred for testing handling adjustments.