Yokomo YOKSD430BS 1/10 On-Road SC430 Drift Shell - Droop Yamasa Yokohama  [YOKSD430BS]

Yokomo SD-430BS - 1/10 Drift Body Droop Yamasa Yokohama SC430
Price:
NZD$76.27
Brand:
Yokomo
Model:
YOKSD430BS
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Scale drift body overview and use

The Yokomo YOKSD430BS presents a scaled SC430 drift silhouette with Droop Yamasa Yokohama graphics and is intended for 1/10 on-road drift chassis. This shell is marketed as a cosmetic and setup component to be used alongside standard 1/10 chassis configurations for practice and competitive drifting.

Builders should prioritise fit checks and clearness at wheel arches. The description concentrates on clearance, mounting approach and how the body integrates with tuning adjustments rather than on decorative detail alone.

Mounting guidance: align standard body posts and mark hole positions before cutting; some trimming around the arches or lower valance may be needed depending on wheel diameter and offset. Use recommended polycarbonate paints and adhesives when decorating the shell.

Specifications

  • Item: 1/10 drift body set, SC430 Droop Yamasa Yokohama styling
  • Model Number: YOKSD430BS
  • Material: Not specified by source
  • Compatibility: 1/10 on-road drift chassis

For tuners and hobbyists aiming for accurate scale appearance without compromising clearance, this shell integrates with typical 1/10 drift platforms; always perform a mock-up to check wheel and suspension interference.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What should I inspect to ensure durability when fitting this shell?

Inspect areas around the mounting points and wheel arches for thin sections, and reinforce with polycarbonate-safe tape if you plan to run aggressive tyre clearance or low ground clearance setups.

Does the body come pre-cut for vents or trims?

Most shells arrive uncut and require the builder to trim vents and holes to taste; follow the lines on the shell and trial-fit before committing to permanent cuts.

Any special care for the Droop Yamasa Yokohama finish?

Treat decals and printed finishes with gentle handling; use mask and light coats for paint, and avoid strong solvents that can lift printed graphics.

Will reinforcement be needed for repeated contact?

If you expect frequent contact with obstacles or aggressive entries, add reinforcement tape or internal bracing at stress points to prolong the shell's service life.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved