The Yokomo YOKTW2413 comes as a matched left/right wheel pair, echoing the Enkei RP-03 spoke layout for use on 1/10 scale drift machines. Supplying a pair improves symmetry for visual checks and consistent tyre mounting during setup work.
Fitment is governed by hub and hex configuration; confirm your car's wheel hex size, hub design, and wheel nut clearance before attempting to fit. Typical installation will use standard hex adapters and a secure nut, and you should inspect for contact with suspension parts or bodywork on lowered builds. Good tyre seating and balance are key to stable slide behavior.
In tuning practice, wheel width, offset and profile change the car's slip characteristics when paired with drift tyres. Use this set to trial different tyre compounds and widths, and to fine tune toe, camber and weight transfer for predictable drift lines. Always treat this as an aftermarket RC accessory and verify compatibility with your specific 1/10 chassis.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved