Yokomo YZ-202B Servo Saver and Wing Mount for Works'91 TeamSpec YZ-W91 / YZ-W91TS  [YZ-202B]

Yokomo YZ-202B Servo Saver/Wing Mount (Black) for Works\\\'91 TeamSpec
Price:
NZD$16.25
Brand:
Yokomo
Model:
YZ-202B
GTIN:
3888
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $23.53 each $-14.54 or -45%
3+ $20.33 each $-12.20 or -25%
Write a review

Product summary: servo saver with rear wing mount

The Yokomo YZ-202B functions as an RC servo saver and rear wing mount in a black finish, intended for use on Works'91 TeamSpec chassis. It is supplied as an accessory or replacement item to secure the rear wing and to interface safely with the servo linkage on YZ-W91 series vehicles.

Use is limited to the listed chassis types; this part is described solely as a model component for setup, tuning, and maintenance and is not suitable for full-size vehicle applications.

Specifications

  • Item Servo saver and wing mount
  • Material Black material
  • Model Number YZ-202B
  • Compatibility Works'91 YZ-W91TS / YZ-W91

Fit this mount when replacing damaged servo saver parts or when securing a rear wing during setup; verify the chassis model before fitting.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Which specific chassis codes are supported?

Support is confined to Works'91 TeamSpec chassis identified as YZ-W91TS and YZ-W91. Confirm your chassis code matches one of these models prior to purchase.

Does the part include mounting screws?

The package lists the servo saver and wing mount only. Fasteners or additional wing fittings may need to be sourced separately depending on your current setup.

How should I inspect the part for wear?

Regularly check the mounting faces and linkage contact points for signs of abrasion or deformation; the part is intended to be sacrificial to protect the servo.

Any setup suggestions for consistent wing alignment?

When fitting, centre the wing on the mount and tighten fasteners incrementally. Re-check the servo travel to avoid binding and make fine adjustments during track testing.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved