Yokomo Z2-002TA Main Chassis Plate for YZ-2T  [Z2-002TA]

Yokomo Z2-002TA Aluminum main chassis for YZ-2T
Price:
NZD$64.68
Brand:
Yokomo
Model:
Z2-002TA
GTIN:
0639342195121
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - Off-Road Chassis Parts category
Write a review

Precision milled main plate for YZ-2T

The component serves as the principal chassis plate for the 2WD YZ-2T racing truck. Manufacture uses high-strength aluminum with milling to trim weight while keeping structural integrity.

Both sides of the plate have formed bends created during machining to boost chassis rigidity compared to a plain flat plate. Supported chassis are noted as B-YZ2T in the listing.

Install this part as the central structural plate on YZ-2T builds and confirm compatibility details against your current build before purchase.

Specifications

  • Item: Aluminum main chassis
  • Material: High-strength aluminum
  • Model Number: Z2-002TA
  • Compatibility: YZ-2T, B-YZ2T

A machined aluminium main chassis option that increases plate stiffness for YZ-2T platforms; refer to the compatibility list for B-YZ2T before fitting.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How do I confirm the Z2-002TA will fit my YZ-2T?

Compare the part's compatibility note listing YZ-2T and B-YZ2T with your truck's chassis code. If in doubt, measure mounting hole positions and compare to the seller's specification sheet.

Will the milled design reduce overall weight?

Yes. Milling removes material where strength is not required, lowering mass while preserving load-bearing sections to retain stiffness.

Are special tools needed to fit this chassis?

Standard RC assembly tools are typically sufficient. Keep appropriate hex drivers and torque control available and verify if additional spacers are required for your setup.

Should I expect any trimming or prep work?

The part is supplied machined; minimal finishing is expected. Inspect edges for machining burrs and clean mating surfaces before assembly to ensure correct fit.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved