Yokomo Z2-008F3G Graphite Front Arm Type-B for YZ-2DTM3 and CAL3  [Z2-008F3G]

Yokomo Z2-008F3G Graphite Front suspension arm Type-B (?3 Suspension pin) for YZ-2DTM3/CAL3
Price:
NZD$18.34
Brand:
Yokomo
Model:
Z2-008F3G
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - ROR-010 category
Write a review

Graphite gull front arm engineered for YZ-2DTM3 and CAL3

This gull-type front suspension arm is designed for 1/10 YZ-2DTM3 and CAL3 series cars as a stiffer replacement to standard plastic arms. The graphite-containing resin raises torsional stiffness to refine steering precision and enhance feedback while adjusting suspension settings at the track.

The part uses Type-B gull geometry and installs as a direct swap for the original front arm on compatible chassis. Pin sizing can vary by chassis, so check the pin style and length on your car before fitting. Installation follows the usual front arm replacement steps and reuses the chassis mounting hardware.

Choose this arm when you need reduced front flex under steering loads, especially when tuning for entry feel and mid-corner balance. It is supplied as an RC component intended solely as a suspension upgrade for model use.

Compatibility

  • B-YZ2DTM3
  • B-YZ2CAL3
  • B-YZ2DTM31
  • B-YZ2CAL31
  • ROR-010
  • ROR-010RTR
  • ROR-010RTR-1
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will I need different pin lengths or diameters to fit this arm?

Pin requirements depend on your chassis and steering setup; inspect the existing inner and outer pin fit and order pins to match if necessary.

Is the Type-B gull geometry a direct replacement?

Yes, it is intended as a direct replacement for the factory front arm on compatible YZ-2DTM3 and CAL3 chassis, though small adjustments may be needed for optimal alignment.

Does graphite construction alter wear or maintenance?

Graphite-resin parts are firmer than typical plastics; inspect mounting points for proper fit and periodically check for stress marks during routine maintenance.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved