Yokomo Z2-008R3A Type-B Rear Arm for YZ-2DTM3 and CAL3  [Z2-008R3A]

Yokomo Z2-008R3A Rear suspension arm Type-B (3 outer pin) for YZ-2DTM3/CAL3
Price:
NZD$16.86
Brand:
Yokomo
Model:
Z2-008R3A
GTIN:
0639342216000
Condition:
Brand New
Write a review

Upgrade Your YZ-2 Rear End with Yokomo Z2-008R3A

The Yokomo Z2-008R3A Rear Suspension Arm Type-B is engineered for hobbyists who want tighter control over the YZ-2DTM3 and CAL3 rear geometry. The arm features a 3mm outer pin and a 3.5mm inner pin to keep the suspension pivot consistent lap after lap.

Models Covered and Spec Notes

Built for the YZ-2 chassis family, this rear arm fits these variants:

  • B-YZ2DTM3
  • B-YZ2CAL3
  • SOR-020D
  • B-YZ2DTM31-1
  • B-YZ2CAL31-1
  • SOR-010
  • ROR-010
  • ROR-010RTR
  • ROR-010RTR-1
  • SOR-020
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can I swap this arm into older YZ-2 kits?

In most cases yes, as long as the chassis uses the same mounting points. Verify pin and mount clearances before final assembly.

Does the arm require special maintenance?

Routine inspection of pin wear and keeping mount areas clean is recommended. Replace pins if you notice play to maintain handling accuracy.

Which surfaces suit this arm best?

It performs well on carpet and loose packed dirt where consistent rear pivot behaviour helps with corner exits. Adjust shock and toe settings to match the surface.

Will using this arm affect camber settings?

The arm itself does not change static camber, but because it alters pivot stiffness you may need to recheck camber and toe during setup tuning.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved