Yokomo Z2-200NTA Steering Set for YZ-2T Bellcrank Centre Link Servo Mount  [Z2-200NTA]

Yokomo Z2-200NTA Bell crank/Center link/Servo mount/Servo horn for YZ-2T
Price:
NZD$26.57
Brand:
Yokomo
Model:
Z2-200NTA
GTIN:
0639342195503
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - Off-Road Chassis Parts category
Write a review

Replacement steering parts for YZ-2T chassis

This resin component set supplies the necessary steering pieces for 1/10 scale YZ-2T 2WD models. It groups the bell crank, centre link, servo mount and servo horn into a compact replacement kit aimed at hobbyists and race crews managing repairs and setup adjustments.

Compatibility is shown in the specifications to help confirm fitment prior to purchase. Resin parts are chosen for their low mass, making them useful as spare components when quick changeovers are needed at the track.

Installation guidance: mount these parts at the original YZ-2T chassis points and use the vehicle's standard hardware and servo interface. After installation, check that the servo is centred, that the horn is orientated correctly and that the bell crank moves freely before final clamping.

Specifications

  • Item: Bell crank / Center link / Servo mount / Servo horn set
  • Material: Resin
  • Model Number: Z2-200NTA
  • Compatibility: B-YZ2T / B-YZ2DTM2 / B-YZ2CAL2 / B-YZ2DTM2S / B-YZ2DTM3 / B-YZ2CAL3

Fit this set to YZ-2T series 1/10 2WD trucks when you need to replace worn steering parts or to tweak steering geometry during setup.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What is the correct sequence to fit these steering parts?

Install the servo mount first, then the bell crank and centre link, using the original mounting points. Fit the servo horn last and perform a steering-centre and throw check before tightening all fasteners.

Do these resin parts accept common servo spline types?

The servo mounting and horn geometry match standard YZ-2T interfaces, so typical servo splines and horns used on that platform will be compatible when aligned correctly.

How should I set steering throw after replacement?

With the servo centred, adjust the horn position to achieve equal left and right travel. Use small increments when trimming throw to preserve predictable steering response on track.

Any precautions when using resin parts on the YZ-2T?

Avoid over-tightening fasteners and inspect parts after impacts. Resin performs well for light use and spares but inspect regularly for cracks or deformation following heavy contact.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved