Yokomo Z2-300FL0A Aluminium Front Lower Mount for YZ-2  [Z2-300FL0A]

Yokomo Z2-300FL0A Aluminum F Lower Suspension Mount(25?) for YZ-2
Price:
NZD$32.74
Brand:
Yokomo
Model:
Z2-300FL0A
GTIN:
0639342195671
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - Off-Road Suspension Parts category
Write a review

Aluminium Front Lower Support

This aluminium front lower suspension mount is made for the 2WD YZ-2 chassis and replaces the molded plastic lower mount with a precision-machined aluminium unit. The inner arm pin pocket is set to a 25 degree skid orientation and edges are chamfered for a neat finish.

Functioning as a service and tuning component, the mount increases stiffness over stock plastic, keeps factory mounting positions intact, and interfaces with the existing suspension pins and related hardware for the compatible chassis variants.

Fitting is straightforward on YZ-2 style layouts: remove the front lower arm pins, swap the mount, and reuse compatible fasteners when condition allows. This part is supplied for hobby model use only.

Specifications

  • Item: Front lower suspension mount (fits left or right as applicable).
  • Material: Aluminum.
  • Model Number: Z2-300FL0A.
  • Compatibility: B-YZ2T / B-YZ2CAL2 / B-YZ2DTM2 / B-YZ2DTM2S / B-YZ2DTM3 / B-YZ2CAL3.
  • Feature: Inner suspension arm pin built to 25 degree skid angle; chamfered edge finish.

Use this aluminium mount to replace degraded plastic pieces or when you want a machined option that keeps mounting geometry consistent on YZ-2 based 2WD off-road models.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What is the recommended fitting procedure for this mount?

Remove the front lower arm pins, replace the plastic mount with the aluminium unit, and refit the original pins and screws where they remain serviceable. Check pin wear and replace if needed.

Should I change torque settings for aluminium parts?

Use standard model-grade torque for small aluminium parts and avoid over-tightening. If you are unsure, tighten progressively and verify secure fit without stressing the bracket.

Can I expect different wear characteristics than plastic?

Aluminium resists deformation better than plastic, so mounting points stay true longer. Inspect mating pins and hardware as they can show increased wear when paired with harder metal surfaces.

Do I need shims or spacers to maintain alignment?

The part is machined to match original mounting locations; shims are not normally required. If you notice alignment variations, verify arm pin condition and chassis geometry before adding spacers.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved