Yokomo Z2-415RDCA Rear Carrier Hard Compound for YZ-2DTM3/CAL3  [Z2-415RDCA]

Yokomo Z2-415RDCA Rear hub carrier/Bushing (3 pin/Hard type) for YZ-2DTM3/CAL3
Price:
NZD$20.26
Brand:
Yokomo
Model:
Z2-415RDCA
GTIN:
0639342216666
Condition:
Brand New
Write a review

Tune Your YZ-2DTM3/CAL3 with the Yokomo Z2-415RDCA

This rear hub carrier is built to tighten handling for the YZ-2DTM3 and YZ-2CAL3. The slightly harder resin enhances rear response and lets drivers dial roll center changes by fitting alternate bushes, helping to stabilise cornering on tighter circuits.

Compatibility and Practical Details

Compatibility covers B-YZ2DTM3, B-YZ2CAL3, B-YZ2DTM31-1, B-YZ2CAL31-1, SOR-010, SOR-020, SOR-020D, ROR-010, ROR-010RTR, and ROR-010RTR-1. The part supports ?3mm suspension pins so it pairs with common pin sizes without extra modification.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will the harder material affect crash resistance?

The harder resin improves handling feedback but can be less forgiving under severe impacts than softer compounds. Inspect for damage after heavy contact.

Which bushes change the roll centre?

Use the bushes specified for altering roll centre; swapping them adjusts rear geometry. They are intended to work with the carrier and ?3mm suspension pins used on your chassis.

Is extra setup needed after fitting this carrier?

After installing the carrier, check toe, camber and ride height as small changes in stiffness can alter handling balance. Make incremental adjustments when tuning.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved