Yokomo Z4-008F1 Flat Front Arm for YZ-4 Track Tuner  [Z4-008F1]

Yokomo Z4-008F1 Flat type Front Suspension Arm L/R (+1) for YZ-4
Price:
NZD$8.48
Brand:
Yokomo
Model:
Z4-008F1
GTIN:
3888
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - YZ-4 category
Write a review

Refine YZ-4 Cornering with Yokomo Z4-008F1

The Yokomo Z4-008F1 Flat type Front Suspension Arm uses graphite-enhanced resin to tighten steering response and improve stability on high-traction surfaces. Its flat architecture helps the YZ-4 slice through turns with steadier weight transfer and reduced understeer.

Fitment Notes and Handling Benefits

Designed around the YZ-4 chassis mounting points, this arm increases front stance for better lateral grip. Note that the extra width may push your model beyond a 250mm race limit seen in some series; simple axle or nut adjustments typically bring the width back into line.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can I use this arm with aftermarket hubs?

Aftermarket hubs can work if their mounting geometry matches the YZ-4 pattern. Double-check hole spacing and bearing fit before swapping components.

Will this change my suspension geometry?

Yes, the flatter arm shifts roll characteristics and track width. Expect a firmer turn-in and adjust camber, toe, and shock settings to dial in balance.

How should I maintain these arms?

Keep the mounting holes and ball studs clean and inspect for wear regularly. Wipe off grit after outdoor runs to prevent premature abrasion of the resin.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved