YS DZ70 Service Push Rod YSG7040 Replacement for DZ70 Engines  [YSG7040]

YS ENGINE PUSH ROD DZ70 #G7040
Price:
NZD$9.78
Brand:
YS Engine
Model:
YSG7040
GTIN:
4562101335956
Condition:
Brand New
Write a review

YS DZ70 valvetrain push rod

The YSG7040 is supplied as a single replacement push rod intended for YS Engine DZ70 glow engines to restore correct valve actuation and linkage geometry.

Use this part when the installed push rod shows signs of wear, has bent, or exhibits excessive endplay that impacts valve timing. It conveys motion from the cam or rocker to the valve lifter, so maintaining straightness and a correct fit is critical for consistent idle and running characteristics.

Replacement is done at component level: remove the rocker/valve linkage fasteners, withdraw the worn push rod and install the new YSG7040, then reassemble and verify valve clearance and unobstructed travel through the engine's range. Confirm smooth operation and correct clearances before returning the engine to service.

Compatibility: For DZ70 series YS RC glow engines.

Is the YSG7040 the same shape as the original push rod?

The YSG7040 is manufactured to match the service profile of the original DZ70 push rod so it fits the existing valve linkage when installed correctly.

How durable is this replacement under regular use?

Durability depends on operating conditions and maintenance. Replace the push rod if you notice wear at the contact points, bending, or any loss of straightness that could alter valve timing.

Can I reuse the old retainers when fitting the new rod?

If the retainers and fasteners are in good condition with no thread damage or distortion they can be reused, but always inspect them and replace any hardware that shows wear to ensure secure retention.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved