YS Engine YSG7063 DZ70 Regulator Body Replacement  [YSG7063]

YS ENGINE REGULATOR BODY DZ70 #G7063
Price:
NZD$21.45
Brand:
YS Engine
Model:
YSG7063
GTIN:
4562101336014
Condition:
Brand New
Write a review

Service Replacement: YSG7063 for DZ70

This component is an RC-scale replacement identified as YS Engine YSG7063 and intended specifically for DZ70 regulator assemblies. It is provided to restore the regulator housing on compatible DZ70 units and does not imply wider vehicle compatibility.

Install this replacement when you are performing routine service, bench checks, or preparing the regulator for tuning procedures. The notes focus on correct fit and installation practices rather than performance claims.

Before fitting: check the mating surfaces and seals, confirm mounting point alignment, and use recommended threadlocker or torque settings for your engine hardware. Supplied as a single unit, it is suitable for workshop servicing and basic field repairs.

What tools and materials do I need to fit this regulator body?

Basic hand tools, a torque driver for correct fastener tightening, replacement seals if worn, and appropriate threadlocker are recommended to ensure a secure installation.

Should I replace seals when installing the YSG7063?

Yes. Inspect existing seals and replace any that show wear to prevent leaks. New seals improve reliability after reassembly.

Are there recommended torque values for the fasteners?

Follow the torque specifications provided for your engine hardware. Use moderate torque and check for proper compression of seals to avoid distortion or leaks.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved