YS Engine YSS2035 Replacement Screws for 56SR Carburetor Set  [YSS2035]

YS ENGINE CARBURETOR SCREWS 56SR #S2035
Price:
NZD$5.49
Brand:
YS Engine
Model:
YSS2035
GTIN:
4560105741896
Condition:
Brand New
Write a review

Replacement screws for the 56SR carburetor

This YS Engine YSS2035 kit provides RC-scale replacement screws listed for the 56SR carburetor series. The set is designed to support disassembly, cleaning and accurate reassembly of model carburetors.

Installation tips: verify the YSS2035 numbering and visually check that head style and thread length match your 56SR parts before installing. Clean mating surfaces and apply correct torque in small increments to preserve thread integrity. The screws secure needles, linkages and housing parts so they influence setup stability and tuning repeatability.

Packing information was not specified in the source listing; confirm pack contents with the seller prior to purchase.

How do I check thread compatibility for the 56SR?

Measure the existing screw diameter and thread pitch on your 56SR carburetor and compare to the replacement screws or request measurements from the seller to ensure the YSS2035 set will engage correctly.

Any special steps when refitting after a rebuild?

During rebuild, reassemble parts dry first to confirm alignment, then fit the YSS2035 screws finger tight before final torque. Check throttle action and needle seating as you tighten to avoid misalignment.

Can I lubricate these screws for easier removal later?

Light use of an appropriate thread lubricant on non-critical mating surfaces can ease later removal, but avoid getting lubricant where fuel or needles seal, and do not use heavy greases that attract dirt.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved