YZ-2 Rear Mount Height Spacer for precise setup - Yokomo Z2-300RSA  [Z2-300RSA]

Fine-tune rear arm height on your YZ-2

This is an RC-scale rear suspension mount spacer engineered for the Yokomo YZ-2 family. The spacer sits between the plastic rear mount layers so you can make smaller, controlled increments to rear suspension arm height without altering the original parts.

Use this spacer during setup to adjust roll centre and ride height or to correct geometry after swapping mount plates. It stacks with the factory plastic pieces and is intended only for controlled offsets rather than replacing any mount components. Proceed with small changes and evaluate handling after each change.

Fitment is simple: loosen or remove the rear mount as needed, insert the spacer at the chosen position between the plastic mount layers, then reassemble and check alignment. Re-check suspension travel and clearance after adjustment.