Zero Cero Front Lower Suspension Arm for 3racing - O-3CP016F by 3Racing  [FP-O-3CP016F]

Front lower suspension arm, Zero Cero fit

This aftermarket front lower suspension arm is built for the 3racing Zero Cero chassis and supplied as one item. It acts as a direct swap to recover steering geometry and front linkage after wear or minor impacts without changing the chassis layout.

Compatibility is limited to the 3racing Zero Cero chassis. The arm aligns with the stock mounting points and pairs with the standard front hub carriers and steering knuckles fitted to that model, enabling installation using the original hardware and bearings.

Fitting is simple for enthusiasts familiar with basic repairs. Take off the wheel and hub, remove the upper and lower linkage pins, replace the arm, and reassemble while verifying free suspension movement and correct toe and camber. Keep original pins and bushings if serviceable and check for interference with the servo saver and front drive components.

In practical tuning terms this part is primarily for maintenance rather than a performance overhaul. Installing a fresh O-3CP016F returns consistent steering response and predictable suspension action, helping when dialing in toe, camber, or shock mount settings.