Zero Cero Rear Lower Arm Replacement O-3CP016R by 3Racing  [FP-O-3CP016R]

Lower rear arm compatible with Zero Cero

This product is a single aftermarket rear lower suspension arm intended for use on the 3Racing Zero Cero chassis and is supplied by Factory Pro as O-3CP016R. It is designed to replace a worn or damaged lower arm and to be used for regular setup or repair tasks.

The component establishes the rear hub position relative to the chassis and affects camber and toe behaviour under load, so it plays a key role in suspension geometry and overall handling. Fit it when you require repeatable suspension settings or a direct replacement of the factory part.

Fitting is straightforward: remove the wheel and hub carrier if necessary, swap the arm while keeping the existing pins and hardware, then check that the suspension moves freely and the alignment is correct. No specialist tools are required beyond standard hex drivers and pliers.

Compatibility: Intended for 3Racing Zero Cero chassis, rear lower arm position only, sold as 1 pcs.